Power comander info needed

[Ryan Verrecchia]

So I just did a whole new motor job and everything all brand new I have to instal a power comander because of the upgrades. I don't have to power up cables so im woundering puting it up on a stand and pinning it will that do and I don't want to beat the brand new engine hard so im worried to do this. Will it just take a quick full throutle to calibrate it or take the engine to get to high rpms thanks.

 

[kovs]

You don't need any special cables to power sled to do the tps match
A couple pieces of 14 ga wire with ends bared, out into ECM power and 10amps is lots from a battery charger or even a battery
Much easier this way to read your 3 decimal voltage


Sent from my iPhone using Tapatalk

 

[Luvinit]

The power up wires are just in front of the oil tank, just push two copper wires into them and alligator clip on a battery, much safer then pinning it.

 

[Ryan Verrecchia]

Alright thanks guys