polarischik
Active member
Just got a new Axys and usually keep the stock can. I also happen to like a hot lunch! Anyone mount a muffpot and if so where? Want to share a picture?
Muff pot on Axys
- Thread starter polarischik
- Start date
takethebounce
Active VIP Member
I am not sure it can be done but I have heard it could. It was hard enough on a stock Pro can but with a piece of aluminum angle plate between where the can and pipe connect it was able to fit. The Axys can is even larger but I will post a picture to give you an idea how we did it on the Pro's.
https://www.hardcoresledder.com/forums/attachment.php?attachmentid=523582&stc=1&thumb=1&d=1326661094
- Thread starter
- #3
polarischik
Active member
I had a pro. Got it in and then tried to do it on my Axys and I’m like
takethebounce
Active VIP Member
I had a pro. Got it in and then tried to do it on my Axys and I’m like
Snowest forum may have some ideas. Otherwise you may be looking for a can.
Dragonalain
Active VIP Member
I riveted my muff pot base to the top on my muffler works great. It burns food if it’s in there too long.
LUCKY 7
Active VIP Member
any pics?
Dragonalain
Active VIP Member
Not on this phone and the sled is up on some pallet racking in the shop maybe I’ll crawl up there tonight and snap some
Dragonalain
Active VIP Member
Does it not leak exhaust through the rivets/holes?
I was thinking of tacking it on there with the welder.
robu
New member
I did the same mount on my sons Axys! the pipe is double walled! Just make sure u drill and rivet into into the first wall or outer surface of the pipe! Looks and works perfect. I don't think you would want to weld it on as there was insulation between the two walls of the pipe.
Dragonalain
Active VIP Member
I have not seen any exhaust residue around the rivet holes yet. I used structure rivets for the job they grab way harder than standard rivets.
Apparently double wall, so rivets only into the void space between.
Not stainless yet. I’ll switch them out if needed due to issues.
Wanna stay quiet on this sled. If it doesn’t work out I’ll change the whole exhaust out. Maybe find a extra pony or two. But Wanna put some seat time in first.
Hot sausage McMuffins on me!
+SLEDWRECKS+
Active VIP Member
Warm at best !
None for you with that attitude!
+SLEDWRECKS+
Active VIP Member
Lol ! Don't burn your tongue on that sizzling sausage bro.
thriller
Member
I know this is an old post but was wondering if anyone was using the mbrp trail can with a muff pot? I mounted it right after the joint going to the MBRP. I tried but in the powder, my exhaust temps seem low at between 90-110F.
Similar threads
