Low end stutter on 800etec

RobertL

Member
Joined
Dec 29, 2008
Messages
20
Reaction score
2
Location
Northern Alberta
Just bought a used 800etec with ~800km on the engine. When you hit the throttle it has a bit of a stutter but then perks right up. Was going to put some miles on it and see if it goes away but thought I’d put it out there to see if anyone has any suggestions?
 

tex78

Active VIP Member
Joined
Feb 5, 2010
Messages
17,517
Reaction score
16,885
Location
DA Moose B.C
Just bought a used 800etec with ~800km on the engine. When you hit the throttle it has a bit of a stutter but then perks right up. Was going to put some miles on it and see if it goes away but thought I’d put it out there to see if anyone has any suggestions?
What elevation, and what clicker ya on??
 

pfi572

Active VIP Member
Joined
Mar 10, 2010
Messages
6,064
Reaction score
15,262
Location
Grande Prairie
What Tex asked as its not loading the motor enough.
Etec’s are bad for this but easy fix .
Clicker up towards #1 will solve the problem.
 

52weekbreak

Active VIP Member
Joined
Jun 17, 2013
Messages
1,929
Reaction score
4,058
Location
SPAB
Had a similar issue on my 800 ETC. Turned out to be reeds. Worth a look.
 

turboetech

Active VIP Member
Joined
Nov 8, 2011
Messages
901
Reaction score
1,358
Location
Alberta
What rpms you pulling at wot..... start with the above mentioned clicker adjustment.... turn to 1.... pinner check rpms... think the etecs are around7800- 8000 rpm max
 

Bnorth

Active VIP Member
Joined
Dec 18, 2010
Messages
10,547
Reaction score
20,126
Location
Salmon Arm
It's the built in 'rpm rate of increase' limiter. As said needs more load. At your elevation go to clicker 1 and even then may need to add pin weight as they are clutched for 3k'-10k' and you are way on the low end of that and probably in thin snow right now.
 

1100

Active VIP Member
Joined
Sep 7, 2008
Messages
1,198
Reaction score
1,631
Location
sangudo
It's the built in 'rpm rate of increase' limiter. As said needs more load. At your elevation go to clicker 1 and even then may need to add pin weight as they are clutched for 3k'-10k' and you are way on the low end of that and probably in thin snow right now.
When this happens does”rpm rate of increase” show on gauge display?
 

52weekbreak

Active VIP Member
Joined
Jun 17, 2013
Messages
1,929
Reaction score
4,058
Location
SPAB
You think reeds at that low mileage?

Mine went at 800 KMs. Only think I could recall was a backfire when doing a hot start the spring before. One set cracked but replaced both sets since we were there already.
 
Top Bottom