Looking for a good machine shop in Edmonton

Alberta Beach Doo

Active member
Joined
Jan 16, 2011
Messages
103
Reaction score
111
Location
Lac St Anne
Seized the old 98 XC700 the other day. I broke it all down and the only issue is the PTO side connector rod has almost 1/4" slop on the crankshaft. The mag is a wee bit loose but that's probably due to the 5500 miles on the sled. I have the motor out and would like to take the bottom end to a machine shop to have them split the case and install a new set of bearings on the crank. Does anybody have any recommendation as to where to take the lower end? Thanks in advance
 
Top Bottom