Jack shaft

[marchuk]

Cant seem to get the jack shaft out of my 2012 freeride ran into some problems on the caliber side looking for any kind of info

 

[teeroy]

jackshaft or driveshaft? brake caliper is on the driveshaft, there is a puller for removal of the rotor. it can be done without, but you have to be careful not to break the plastic plug

 

[Maxwe]

you must mean the drive shaft. try this Removing drive shaft tips? - REV-XP / XM Chassis - Mountain Sleds - DOOTalk Forums or xp driveshaft removal - SnoWest Snowmobile Forum or

 

[RGM]

to pull the jackshaft I always heat the support that holds the bearing on the left side to help get it out and back in. A propane torch works fine.

 

[team-x]

Make sure you remove the retainer on the bearing. After your sure everything is out, take a torch and heat the bearing support a little. Then I used a dead blow and gave it some persuasion from the chain case side and it came right out