mdtgrizzly
Active member
I have a 2010 grizz with a few mods done to it, I had a machined sleeve in the clutch and it broke itself apart and melted the roller weights, since then I put factory sleeves back in and just kept the epi clutch kit. This was also a problem before, when I put speed up and release the gas there is a bit of a grinding noise, or the bike will stall while still in motion. I dunno if its the one way bearing or a bent shaft that would create this, the primary tho would only spin one way so I would assume the bearing was good. Anyone got any ideas? Thx