happy with my dynoport y , single pipe and the thing can.....really curious how much better a clutch kit would make it perform,over a stock 09 upgrade.
sorry for jackin your thread...
ya really happy with it,sure woke it up in the mid range.coundnt go wrong for 80 bucks,thanks again bill(gml)
yeah. they are pretty good from the factory.
i usually do 19t top gear, dj kit, exhuast system and the shim kit on the 08 ( make ALOT of heat being out of alignment) dj kit has unreal response in the trees. its insane
timbersled working ok for you?
just a set of shims that goes on the jackshaft to force the secondary out to the correct alignment spec..
the alignment specs are provided and you use as many shims as your sled needs they all vary.
the differance is IMPRESSIVE.
on a factory 2008 after a long pull i cant even touch either clutch.
and a 2009 machine i put together this spring with the shim kit is luke warm. barely even melts snow.
shim kit is about 60$ and i will admnit its not PERFECT because the engine moves and the chassis twists. but it gets it pretty damn close.
the best option is the floating clutch conversion. but it runs around 700$
but allows the clutch to be truly alligned to where it naturally wants to be
Where can i find this shim kit?
there is a guy on Dootalk. Here ya go
QRS Shim Package PRICE $45.00 USD
QRS Shim Package
In testing, this kit has shown to reduce belt temps up to 70*f, increase belt life and provide more consistent RPM's. Between my personal sled and the 3 different test sleds have shown zero belt wear with a total test mileage of 3450. Test sleds where a 08 TNT, 08 MXZ-X800R, 08 Summit 800R run @ 1000 – 10000 ft elevations, aggressive trail riding as well as mile after mile of WFO powder riding.
The QRS shim package consists of 5 bearing shims and 3 spacers to support the inner race of the upper chain case bearing. With this package you will be able to shim the secondary 2-5mm and have the proper spacers to support the upper chain case bearing and prevent any oil loss through the upper seal as well as bearing failure due to unnecessary side load.
Simple 20 minute install.
Price will be $45.00 shipped in the lower 48 and $55.00 shipped Canada and Alaska
Pay will be accepted to Dynamicrecovery@comcast.net
Contact Email: Dynamicrecovery@comcast.net
for 1000.00 i can add the dynoport y pipe and pipe. am i gona notice a difference in power for that much. 08 xp 800 i cant seem to find any other kind of pipes to buy?