I spent a few hours yesterday trying to install my X3 track with 7T Avids on my 2014 and could not get the drive shaft to pull over on the quick drive side. I got it as far as just entering the bearing and tried tightening a bolt against a backing plate to pull it over but still no go.
I know this is a tough job and I've changed 2.5 in tracks before but what's the trick? Right now I'm thinking I might need to remove the drive plate but I'm not too keen to start playing with the glue. Any help appreciated.
I know this is a tough job and I've changed 2.5 in tracks before but what's the trick? Right now I'm thinking I might need to remove the drive plate but I'm not too keen to start playing with the glue. Any help appreciated.