can i check codes with cluster?

[dezmitchell]

Had my engine light come on while riding sunday, restarted sled light went away for a few mins then came back. Sled did this all day no loss in performance no codes came up on dash light didnt blink or beep. Can i pull any codes using the cluster ?

Checked gas cap vent and a few simpler things only thing that i could think of but engine light stayed on dont know wtf was hoping i wouldnt have to use the budds system and pay big money

 

[Stg2Suby]

Displaying “P” Codes
(Premium Gauge Only)
1. To activate
P CODE mode, push and hold the
“M” button for 2 seconds.
2. As you hold the “
M” button, quickly turn ON
and OFF the high beams a few times. The
gauge will enter
P CODE mode.
3. While in
P CODE mode, use the “M” or “S”
button to scroll over available failure codes.
4. Push and hold the “
M” button to exit P CODE
mode.
A
NO ACTIVE P CODE message is displayed if
there are no
P CODES in memory.

 

[Stg2Suby]

Sorry for the formatting I just copied above out of the PDF version of the service manual. Hopefully it works havent' tried it myself.

 

[X-Treme]

Aftermarket can? I don't ride a Doo, but from my reading, some cans cause code issues.

 

[dezmitchell]

had the sled shed cooker can on all last year sled didnt even hiccup

 

[zenk]

If it ends up being the can throwing the code, i think the dealer has a computer flash for that to fix it. or so i have read.

 

[neilsleder]

The can throws a muffler code it says muffler across the screen with the temp light on. So I don't think it's that. Was it your first ride? You might of had a shot of bad or old fuel and it hit the nock sensor? Just a guess.


Sent from my iPhone using Tapatalk

 

[MK4TDI]

That little book under the seat actually has some useful information in it. Read it front to back a couple times and one might no more than some of the techs trying to work on these sleds.



Page 163