2008 Torque spec & sequence

scully

Active member
Joined
Jan 12, 2008
Messages
104
Reaction score
102
Location
fort mcmurray
Have a 2008 XP 800R, looking for the cylinder & head torque spec & sequence. If anyone can help it would me much appreciated..
Thanks Scully...
 

pistonbroke800

Active VIP Member
Joined
Sep 1, 2009
Messages
933
Reaction score
835
Location
Airdrie
Initial torque to 11lb/ft starting in the center of the head and tightening in a criss cross pattern working from the middle of the head outward. Then final torque to 21lb/ft following the same criss cross method from the center out.
 

CUSO

Active VIP Member
Joined
Jan 21, 2007
Messages
4,772
Reaction score
5,538
Location
Edmonton
It's an old pic but the sequence is identical

15677d1296462439-bolt-diagram-removeing-top-end-my-toque-specs.jpg





Initial torque to 11lb/ft starting in the center of the head and tightening in a criss cross pattern working from the middle of the head outward. Then final torque to 21lb/ft following the same criss cross method from the center out.
 

CUSO

Active VIP Member
Joined
Jan 21, 2007
Messages
4,772
Reaction score
5,538
Location
Edmonton
Also re-tighten the head bolts after the first ride when cold.
Head bolts 29 N*m (21 lbf-ft)
Cylinder bolts 50 N*m (37 lbf-ft)
1st torque is 25 N*m (18 lbf-ft)
final torque is 50 N*m (37 N*m 37 lbf-ft)
Knock sensor 24 N*m (18 lbf-ft)
Water housing top & bottom 9 N*m (80 lbf-in)
Rave assembly 9 N*m (80 lbf-in)
Rave plastic cover 4 N*m (35 lbf-in)
Carb boots 6 N*m (53 lbf-in)
Case bolts long/large dia 29 N*m (21 lbf-ft)
long/small dia 11 N*m (97 lbf-in)
shorter/large dia 29 N*m (21 lbf-ft)
shorter/small dia 11 N*m (97 lbf-in)
Seal cover pto side 11 N*m (97 lbf-in)
Water pump 11 N*m (97 lbf-in)
 
Last edited:
Top Bottom