Looking for a 3-6000’ clutch set up for a 2017 XF 6000. Would like a set of J14-64 gram weights but would consider J14-62. Anyone got some they are willing to part with?
Looking for a 3-6000’ clutch set up for a 2017 XF 6000. Would like a set of J14-64 gram weights but would consider J14-62. Anyone got some they are willing to part with?
I have a 2017 Axys limited with e start and am wondering about using the USB port that is for updating the PIDD for charging your phone. Has anyone been doing this or is it a no no ?
Read on another site that some people are changing out the stock primary spring to a Speedwerx 120/285. They say it gives you more throttle control, rippy feal so you can really work it and not just pin and hang on. Has anyone done this if so what colour of spring would equal the Speedwerx one...
Gents, still trying to set up this new to me sled and am getting there but just not right yet. I have reset all the shock pressures to the initial setting as per the manual but still seems to have too much ski pressure. Being the limited it has evolve shocks both on the skis and in the skid...
getting the 1100 ready today and when I removed the hood I found a hose from the intercooler laying on the heat shield. I assume it goes over to the middle electrical box with the spigot?
2012 800 Proclimb has a bad bog. Almost puts you over the handle bars if you are standing up. Anyone have any luck with by passing the TSS would like to try this first.
2012 Proclimb has a bad bog almost puts you over the handle bars when riding standing up. Have heard in the past it could be a faulty TSS. Anyone have any luck by passing this? Would like to try it to see if that is it before I go looking somewhere else.
Changed the speed sensor on the HCR, it now reads but it is very erratic. It goes from 0 - 150 back to 75 and all over the place no matter how fast the track is spinning. any thoughts?
I am in the process of replacing the mechanical seal and inner oil seal on my F1000. In the kit with the mechanical seal is a ceramic seal that from what I am being told presses into the impeller, the issue is that the seal at the back of the impeller is the same as the inner oil seal. Did they...
Just wondering if there are any vintage racing events in Alberta? I have been transferred back to AB from Sask and am going to miss the racing that is here. It is growing big time!!! Here is a pic of a couple that have been done over the past couple of years. 73 el tigre, 75 440 trail tister and...
I installed the furnace this weekend now wondering if it took the hot wire from the trailer plug in and ran it to the positive side of the battery in the trailer will it charge as I am travelling? Also what else do I need to do if that will work, run a ground to the battery from inside the...
I picked up and RV furnace 22.5 L x 9.5 W x 9.5 D and rather than mount it and have it stick out 22.5 inches, can I mount it sideways? If it is mounted sideways the burner will be on its side as I need the two vents accessible. Will it operate proper properly?
Noticed yesterday after riding my 07 F1000 for a while that the fuel gauge showed empty even though I had just filled it. Then a short while later a coupleof bars would appear then be gone again. Any thoughts?
Started the wifes 2007 F5 this past weekend and notice that the oil light came on after awhile, and now is on all the time any idea's? And yes the oil jug is full!!!:beer: Possible sending unit?