So, on April 3 I pulled a 27 foot vee nose up to the parking lot at Lumberton, yes we should have left it at the bottom, but I assumed the parking lot would have been plowed or the end cleared/left open to turn around, it wasn't. So thanks to a few fellows from Sparwood and Elkford, we hand...
I'm looking for some one who has a 02 xc sp 800 with electronic reverse to take a pic of their cdi box, looking for a number and to compaire the main plug on the box. I have an 800 engine that I think has electronic reverse, there's no numbers on the block and no sticker on the recoil, the jug...
I have a 800 polaris, I don't know what year it is, I has the RER, the only numbers on the block 0001923 nothing else. I have two sets of exhaust valves, one set are Stainless steel, the other are Titanium. I've heard mixed remarks on the Ti valves, dose anyone have any input on them? and what...
I have a 800, I don't know what year it is, I has the RER, the only numbers on the block 0001923 nothing else. I have two sets of exhaust valves, one set are Stainless steel, the other are Titanium. I've heard mixed remarks on the Ti valves, dose anyone have any input on them? and what they...
Just wondering if the 02 800 edge and the 03-04 vertical escape share the same jack shaft? I have a 03 800 motor with electronic reverse, thats going into the 02 edge, so I need the Team roller secondary.
Thanks.
Hey guys, just wondering if anyone has put a CR tunnel on a 01 Polaris? I helping a friend with his. The tunnels on, but the new cooler tubes run right through where the trialing arm bolt would go onto the foot rests. Just wondering what is comonly done with this, should we modify the trailing...
Well I need some help, my 650 is back fireing through the carbs, but ONLY when its cold. If you rev it up, it gets worse, but if you pull the choke on while doing that it gets better. I've gone through everthing in the carbs and everthing is to spec. I thought maybe it's electrical, but what is...
Making your own ZRT 600 Stingers?
Hey guys, I don't know if I'm in the right place or not, I'm new to this, but I'm wondering about making my own set of stingers for my 600 zrt, and I've herd different things about back pressure in the can. What I'm looking for is dimensions and if anyone has...