Recent content by KDUBS77

So if I understand correctly: The 2" with no mods will fit w/o notching the track? I was seriously considering a 136" x 1 3/4", so your saying that it would not be a problem. Thanks for the input!! :confused:

good luck with it. Just be sure you know were your stock jetting is at so you can use that as a baseline and go from there.:bluesbros:

typically you'd have to go up one or two sizes in jetting for a stright pipe. Silencer cans you wouldn't have to change the jetting, usually too rich anyway (polaris).

The ignition key gives you the option to select regular or prem. In the event that you had no other option and had to fill up with 87, you would just select regular. If you select prem, it will display prem only on the dash. If ever you feel like you got bad gas, you can select regular. I...

So as long as I'm removing the cylinders, you'd might as well replace the pistons at this point!! Polaris or Weisco or does it not matter. I know the cylinders are plated. I would always assume on going with the better part.

anyone? bueller?:rolleyes:

I did check compression. I let the sled warm up. Shut it down and installed guage and pulled it over a few times. I got a reading of about 123 to 125 on the mag and pto. I was thinking the same thing. What is the average life you'd expect out of it? Thanks again.

Help a 'newbie" out would ya! Anything. Something. I know this is a fairly common problem with these and want tonarrow down the possible cause(s). Thanks again.

I'm looking to upgrade the stock .91 track on my 01 600 xc sp this year and was wondering what the lallest lug people have run on this sled. I know 1 1/4' is pretty common, but was leaning twards a 1 1/2-1 3/4. Would I have to notch the track to accomodate the heat extangers. Thanks for...

I've got a 01 Edge with 5000 mile on it that is mostly stock. Stock jetting, boost bottle, clutch kit, and tempa-flow installed. I've used tis setup for over 5 or six years with no trouble. The problem Ive been having is a very low Idle, wants to die! I have cleaned the carbs, checked the...