I have a 2003 chev 1500, the speedometer gauge is burried as far right as it can go, then relaxes to 160. Once it was sitting at 40 when not moving the truck, and would go up from there as you got faster. A week later it went back to working properly. Now it's burried right. What would be the...
Anyone else hear of this? Hay barns all over the states are catching fire now. Rose town, erskine, and two by camrose have all caught fire in the last few weeks.
Has anyone used a workout machine like this, if so what are your opinions good or bad. Says it goes up to 220 lbs. Never tried a unit like this before. Thank you.
What brands have the flattest paintable fender flares around 4-5 inches high, and stick out minimal. I like the bolt look also but just don't like the look from the rear with them sticking out so far.
Have a dodge 2500 gasser 2007. I have stock tires in it which are 265/70/17. Would like to know what tires one can go with for increasing the tire diamiter so it's taller, but would like to keep the width close to what I have now, and must fit the stock rims.
Where does one get red oak plywood 1/2 or 3/4 domestic in red deer, or edmonton. I can get the imported stuff but it's junk, the veneer is so paper thin you can't touch it with a sander without going through it.
Have a quad that the plastic is in really good condition, but faded a little, not much. Is there a liquid or paste to wipe on that doesn't require an electric polisher? Or does one have to use the polisher?
Does anyone know where to get a moose hide tanned with hair on and hair off in central alberta. I know edmonton does it, but was hoping around red deer camrose area. Thanks.
2007 dodge 3/4 hemi. 144000 km. pulling trailer all of a sudden it feels as if the front tires turned square. Get up around 90-115 and goes crazy. Slow down goes away. Some may have called it the dodge death wobble. What parts are likely the issue?
Does anyone know where in alberta to get this wood from? Tried all windsor plywoods and they are all out of stock. It's mahogany/sapele. After darker brown/red straight, no cups or twists. Want 1 - 1/8 x 10 feet.
Was welding today and the gun and hose was acting all jumpy. Then poof, no power to the rollers to feed the wire out. The motor for the welder still humms but no power to the gun. What's the issue?