Recent content by summit670

  1. S

    ski doo clutching

    Thank you all very much, I changed the tension on the secondary, it was almost nothing to start with. I will get new springs for it and see how it does.
  2. S

    ski doo clutching

    This is quite a help, but I have one more question. When i took apart the secondary clutch to clean it I put is together, but did not wind it up properly I was wondering if this could be part of my problem. So there was not much spring power to rewind the clutch when it closed. Also the...
  3. S

    670 summit bogging

    Thanks for the help on that! I also have a problem with my sled realy eating belts. I am not sure what to do. Is is clutch allignment, or could it be that I just had a really dirty secondary clutch? Thanks for the help.:(
  4. S

    ski doo clutching

    I have a 1998 ski doo summit 670 I love the sled it does great in the mountains, but it really eats up the belts. I am not sure what I need to do, I was wondering if worn clutch components can cause this affect. I also need to know if it is likely to be the primary clutch or the secondary...
  5. S

    summit670 help

    I was having the same proboblem on my summit 670. It turned out that when it gets that flooded out the bottom end gets filled up with gas the gas then goes through where the pulse from the engine should be. then the snowmobile won't even run. I turned the gas off then took out and dried out...
  6. S

    I have a question about a ski doo 670x. To adjust the clickers on the clutch do you have to...

    I have a question about a ski doo 670x. To adjust the clickers on the clutch do you have to mess with the secondary As well as changing the front? My problem is the clutch system is really heating up. I am not sure how hot it can get, but when I ride it for a while it gets so hot that I can't...
  7. S

    I have a 1998 ski doo summit 670x that has a bogging and will not rev over about 7000 rpm. I...

    I have a 1998 ski doo summit 670x that has a bogging and will not rev over about 7000 rpm. I think it might be the dpm system, I was wondering if you know how to test it or find out what the problem is? Thanks, Ed
  8. S

    670 summit bogging

    I have a 1998 ski doo summit 670x, it runs great until I start climbing for a while, then it starts bogging and will not rev over about 7000 rpm. I was wondering if it could be the dpm system or what is causing it... Any help or suggestions are appreciated. Thanks in advance
Top Bottom