will a po po 163 2.86 pitch track work in a 163 xp ?

[tex78]

as it says will it bolt on without driver issues ?

 

[imdoo'n]

why not if they are same pitch or close should work, you'll have to reset the drivers to fit track though.

 

[mach123]

Then you can use yours as a rug mat, just saying

 

[magnet]

it will be 1" narrower though. might look goofy in the tunnel. j/s

 

[TheMuffinMan]

Yeah it'll be narrower but who knows...could be the magic fix your buffalo needs Tex. Be the guinea pig!

 

[imdoo'n]

it will be 1" narrower though. might look goofy in the tunnel. j/s

bet you won't even notice it, a half inch on either side, you may have better eyes than me, although that wouldn't take much. still tex just is a little hard on equipment.

 

[teeroy]

bet you won't even notice it, a half inch on either side, you may have better eyes than me, although that wouldn't take much. still tex just is a little hard on equipment.

agreed....the tunnels didn't get any wider when 'doo went to 16" wide tracks.

 

[tex78]

will the drivers match tho

 

[imdoo'n]

well a 2.86 pitch should be the same, and a 3.0 will work with 2.86 drivers, driver teeth width should be the same? ya may need to measure width? otherwise should work, although a poo track on a doo is a little weird.

 

[tex78]

sounds like app have done a few doos with po po tracks

 

[pfi572]

Ran one on my 2008 and worked fine. Track didn't rub the sides and fray and worked just as good as the 2.3x16x163 IMO plus didn't have to worry as much about track being stabbed buy tree or stump due to all the holes in the stock track.