van amberg d&r ???

[bingo1010]

I am getting ready to do the d&r on my 07 and was wondering if anyone out there can tell me if the factory footrests work after the work is done and as well does the factory belt guard work? it looks like the secondary clutch will be well into the footwell area and if I cannot reinstall the footwell then there is no place for the belt guard to attach to, anything else I should be looking at or tips before I get started would be appreciated,

 

[pistonbroke800]

I had a D&R on my rev. The belt guard and the pieces of aluminum at the end of the foot holes I reused just by trimming them down to fit with the drop. Belt guard I also reused just had to move the mounts down a couple inches and it was good to go

 

[pistonbroke800]

Forgot to mention the break rotor cover you can reuse by trimming down the bottom so it will still bolt up to the dropped drive shaft