Truck boss mounted with wood box liner

[Team Pigeon]

It was done. Extend the clips by 1", drill and tap your heart away. Cut access to the bed rails with a template. Clip it down snug, screw the rail to the box liner horizontally and proceed as per normal.




Sent from my iPhone using Tapatalk

 

[rmk 800 144]

How's it work with the slip tank and the sides the fills?


Sent from my iPhone using Tapatalk

 

[77Crash77]

Aren't you afraid of all the crap that is going to be trapped between that box liner and the truck?


Sent from my iPhone using Tapatalk

 

[Team Pigeon]

The pump and fill bungs are aligned to the center of the slide outs. I just slotted them after drilling the 3" holes. Measured a lot. Removed the deck and measured. Measured again with the deck in. Measure measure measure from the sides, from the glass hahahah. Slept on it and measured again in the morning hahahah.

I have covers I'm fabbing out of black crazy carpet that I'm covering the the holes with.... But there shouldn't be any crap flying around there with a deck on top. Never had rot issues in the past with plastic liners.


Sent from my iPhone using Tapatalk

 

[JMCX]

Aren't you afraid of all the crap that is going to be trapped between that box liner and the truck? Sent from my iPhone using Tapatalk

Here is what the box of my last work truck looked like after taking the wooden liner out at 570k.

 

[Team Pigeon]

Hahha. Looked like my 1992 f150 360k plus. Mint.


Sent from my iPhone using Tapatalk

 

[Mike270412]

How's it work with the slip tank and the sides the fills?


Sent from my iPhone using Tapatalk

What?

 

[Team Pigeon]

Used an L-shape slip tank. Otherwise the ramp ends up not fitting.


Sent from my iPhone using Tapatalk