Polaris axys driven (secondary) question

[sledder325]

I removed my driven clutch to clean it. I noticed in behind the clutch (between the clutch and jack shaft bearing there is only one of the 16gauge bushing washers (the thick one) in the manual it says you should have at minimum one .120 washer, so do you think i should add one of those to, i know its for the offset but not sure if you have to have one .120 washer plus more washers. Here is a pic of the manual page explanation.

 

[TROLLCAT]

your 16 gauge bushing is just a fat .120 washer you can just use it is all you need

 

[Teth-Air]

So many guys used to reduce the washers to get more float and this could keep the clutch more centered. No one seems to do that these days.

 

[sledder325]

Does anybody know where you can buy the clutch aligment tool for the axys?

 

[Teth-Air]

Does anybody know where you can buy the clutch aligment tool for the axys?

Will this work for you? I can order them in. Might be $15 freight on top.

 

[sledder325]

Will this work for you? I can order them in. Might be $15 freight on top.

Can you get the ps-51607 that is the one for the axys.
The ps-47477 you have to do extra steps according to the manual.