Ruegsegger
Active member
I tried serching this topic but didn't have much luck. I am heading to Golden next week and was giving my sled a going over when I noticed my front pto side motor mount has come loose and in the process it chewed a decent size hole where the bolt sits in the frame. It looks like the hole in the frame should be square to keep the bolt from turning but I never had one out before so I'm not sure. So if it is supposed to be square how the heck should I go about fixing this? Anyone else run into this before? It would be difficult to weld up and have the hole in the correct position(and a hell of a big job!). Any ideas would be greatly appreciated.