JustChilling19
Active VIP Member
I am posting this up here hoping it will get more traction then in the Polaris section. Have spent more then a few hours trying to drill out the grey rivets on the stock stiffener plate. I believe they are called press rivets? Did some research and they are super hard and a absolute bitch.
Have broken several normal, and now titanium, drill bits on this. Got one side done but gave up after today’s three hours shift.
Does anybody have any tips to do this? In the Polaris section someone suggested a grinder but that is a bit past my comfort level...
Was two seconds away from taking out the impact air tools but thought better of that to haha going to go buy cutting fluid tomorrow and try with my remaining titanium bits lol
Any help is appreciated!
Have broken several normal, and now titanium, drill bits on this. Got one side done but gave up after today’s three hours shift.
Does anybody have any tips to do this? In the Polaris section someone suggested a grinder but that is a bit past my comfort level...
Was two seconds away from taking out the impact air tools but thought better of that to haha going to go buy cutting fluid tomorrow and try with my remaining titanium bits lol
Any help is appreciated!