computer reset

[jeremy]

hey looking for a little help,

I have a fusion 900, 2005, and it has the service engine light on, as it needs it 1000 mile look over. I phoned the dealer, he says the do the chaincase oil and look it over, which any sledder should know how to do himself any how, but how so you reset that stupid computer so it dosent flash that anymore???

 

[fnDan]

This is from the Owners Manual:

To reset the reminder at the existing interval:
1. Enter the service interval screen.
2. Press and hold the SET button for ten seconds, continuing to hold even after the display begins to flash.
3. When the display stops flashing, release the button. The service interval has been reset.
To reset the reminder at a new interval:
1. Enter the service interval screen.
2. Press and hold the SET button for five seconds, until the hours begin to flash.
3. Immediately release the button.
4. Press the button again up to five times to advance the reminder in 50-hour increments.
NOTE: The maximum interval is 250 hours.
To disable the service interval reminder, press the SET button once after reaching 250 hours on the display. The gauge will display “OFF”.

 

[fnDan]

I copied the pages from the 2005 Deep Snow Service Manual that show the service intervals and what needs to be done at each interval.
http://www.members.shaw.ca/grizzlies/images/2005_RMK_Service_Sched.pdf