Clutch torque settings

[Wingwalker]

What is the correct torque setting for a P85 clutch bolt?

Just changed the weights in mine it was a pig to get off but we managed to do it

Have seen a reference on another forum that its torqued to 96ft/lb but my manual says 40/45ft/lbs

So if I keep it in the 40/45ft/lb range will that be ok

 

[rmk mod]

Drive clutch bolt torque

Large ID shaft .75"/19mm 40-45ft.lbs
Small ID shaft .55"/14mm 50ft.lbs


Hope this helps ya out. RMK

 

[900sleddude]

Because of the engine vibration it should be torqued to 96 ft lbs. If you've had the clutch off you need to ride it and re-torque it a couple times because they have been known to loosen once in awhile.

 

[Wingwalker]

Because of the engine vibration it should be torqued to 96 ft lbs. If you've had the clutch off you need to ride it and re-torque it a couple times because they have been known to loosen once in awhile.

Drive clutch bolt torque

Large ID shaft .75"/19mm 40-45ft.lbs
Small ID shaft .55"/14mm 50ft.lbs


Hope this helps ya out. RMK

Thanks to both of you for the information

A buddy of mine phoned a couple of dealers for me with the result that the torque settings in the manual are wrong
What 900sleddude said is correct
so i torqued mine up to 90ft/lbs then removed the bolt and did this again 3 times running the engine up in between each time
Going for a ride tomorrow then will recheck the torque again after that

 

[powder junkie]

90 isnt enuff. make sure its 96. sum guys have gone 94 and it shook loose. 96 is important.

 

[nabr]

i have an o6 700 fusion and mine is 96. they are the same moter so i would torque it to 96. and yes retorque after running it will lossen.