2016 M8000 LTD Not Revving Out

Flick

Active member
Joined
Feb 28, 2008
Messages
43
Reaction score
4
Location
Edmonton
I am having issues getting my sled to rev out to where it should be 8000-8100~.

I currently have 68 weights and a 85-255 drive spring. I am riding in the Fernie area which is around 1800m or 6000'. As per the recommended altitude calibration from cat it states that for 3-6000' I should have 70 weights, 85-235 drive and a 155/240 driven spring. I have not taken the helix apart to see what my driven spring is yet..

I purchased the sled used from Saskatchewan this year and the owner claimed he never had it in the mountains and that the dealership had it set up as stock.

The sled has 1000km. I was able to get around 7950 RPM when I tested the sled out at our cabin which is around 810m or 2650'.

Is anyone able to offer some advice on what might be wrong? The dealerships have really not been helpful and have said some conflicting things.

Thank-you!
 

Pilsner

Member
Joined
Nov 4, 2008
Messages
22
Reaction score
12
Location
Shuswap
Probably something in the secondary, check helix and spring, probably too steep or stiff
 

mountianguy

Active VIP Member
Joined
Apr 26, 2009
Messages
564
Reaction score
694
Location
stony plain
I am having issues getting my sled to rev out to where it should be 8000-8100~.

I currently have 68 weights and a 85-255 drive spring. I am riding in the Fernie area which is around 1800m or 6000'. As per the recommended altitude calibration from cat it states that for 3-6000' I should have 70 weights, 85-235 drive and a 155/240 driven spring. I have not taken the helix apart to see what my driven spring is yet..

I purchased the sled used from Saskatchewan this year and the owner claimed he never had it in the mountains and that the dealership had it set up as stock.

The sled has 1000km. I was able to get around 7950 RPM when I tested the sled out at our cabin which is around 810m or 2650'.

Is anyone able to offer some advice on what might be wrong? The dealerships have really not been helpful and have said some conflicting things.

Thank-you!
Check for a broken primary spring, belt condition and proper belt deflection. After that check the primary weights for bushing wear. These are all little things that can rob a few hundred rpm.
 

Flick

Active member
Joined
Feb 28, 2008
Messages
43
Reaction score
4
Location
Edmonton
Primary spring is not broken. New belt. Deflection is fine. I’ll have a look at the helix.
 

Clode

Active VIP Member
Joined
Jan 8, 2012
Messages
29,504
Reaction score
46,481
Location
BC
I had a roller snap ring pop off, the thrust washer was floating around in the secondary. The loose pieces were getting jammed up causing issues.
 
Top Bottom