2016 Etec swap out tips

FatGuy

Active VIP Member
Joined
Aug 27, 2009
Messages
517
Reaction score
1,681
Location
The CN shack along the tracks by Allen creek.
Hello looked around didn’t find much. But I’m chit at computers.

Swapping a etec with a new short block. Any special tools or tips for this.

I have done lots of Pteks but this is the first Etec’s

Wondering about injectors,flywheel ect

Thanks
 

bobsledder

Active VIP Member
Joined
Jan 11, 2009
Messages
2,824
Reaction score
6,105
Location
Not Sure
Injectors just keep track of mag and pto side and move em over the same to match the ECU programming. Flywheel was simple pull and move over when I did it. Then we hooked up to buds primed fuel pump, purged oil lines, reset break in mode, checked rave valve operation and fired it up.
 

bobsledder

Active VIP Member
Joined
Jan 11, 2009
Messages
2,824
Reaction score
6,105
Location
Not Sure
yes it does. Run fuel pump to refill injector system Oil pump is also electric. Just turn it on in buds when you fire it up and enjoy the smoke show Do it outside lol
 
Top Bottom