Long shot but I rode Gorman December 12 and on the trail out I lost a black 2 piece GoPro pole setup. If anyone happened to pick it up that would be fantastic!
So I pulled both bolts out to adjust the strap and now can't remember what are the stock holes lol.
Anyone able to help a brother out? 2013 154 XM.
Thanks! :D
2013 Summit XMx 154
Has an MBRP can on it..tunnel bags..and a 190lb dry rider(240lbs geared up roughly)
Roosterbuilt clutch kit geared up 1 tooth.
The paperwork came with a suggested pin weight of 15.9g
The sled would only run 7600rpm on clicker 4, Silent Pass, Reve, Sicamous...
As I dont...
Does anyone have some kicking around for doo clutches(xm/xp style primary)... I have all of the tools in a handy carry case that gets lent out... Well it never came back with the button holders. Looking to get my local laser shop to cut me some replacements and would like some measurements...
Any able to throw a pic or two up of where they put their non cable scratchers on the rails? I found a pic on snowest and I must have different scratchers but a C-Hair because she dont work.
Im tired of having my bladder poked by the mountain bar handle on my XM. Ive seen posts where guys heat them up and bend them forward... kinda chingy changy IMO.
any suggestions for a new bar setup?
Where is everyone washing their vehicles? 1 ton GMC in question. Decent size bay with hot water, lots of pressure and charges accordingly?
Hughes is so hit and miss they piss me off, tried a couple small washes hoping Id get lucky. Rock n wash had very light soap, pressure was weak and truck...
Near the end of last season I put a MBRP race can on my 13. Has roosterbuilt clutching/gearing and a race can. After I put the MBRP can on, I noticed a lack of throttle response when wacking the throttle from out of the hole, Like the sled would cough/sputter. But would clean up once you got out...
Hey guys/gals. Looking to purchase cognito upper control arms and some shocks for my 08 duramax. Who should i use in the city to get the best prices/service? I'm familiar with what I should pay just not with who I should give my money too.
thanks!
-Matthew
I'm a fairly new member here but have quite a few friends that frequent this site. I'm on a quest for a Can am of sorts. 2010+ renegade or outlander. But at any rate I would like to share a story and a heads up on a quad.
Quad in Question is a 2010 Renegade XXC with mudlites, center skid plate...