Got a tki belt drive and the inner edge of the belt is running up onto the edge of the idler pulley. Used kit. Vague instructions. Anybody able to tell me if it’s ok to run without washers between arm and pulley so I can get the pulley moved over?
Hey there. Have done lots of searching and now I’m asking. New cvtech crankshaft does not have the index mark in the end of the pto stub. Question is “what does the mark in the pto stub identify?”
I know all about lining the clutch up and what marks go where but can’t find anything that tells me...
So silly mistake. But has anyone used a stock bore head gasket for a can am 800 on their 840 bbk. Put a new head on my unit and grabbed a head gasket off the shelf just to find out I still have the 840 one on the shelf.....
So silly mistake. But has anyone used a stock bore head gasket for a can am 800 on their 840 bbk. Put a new head on my unit and grabbed a head gasket off the shelf just to find out I still have the 840 one on the shelf.....
Been looking into shr's relocate brackets but wondering what the measurements are ( how far back and down)? Thinkin this hole in the race could be used as a guide to poke a new hole
Sent from my SM-G900W8 using Tapatalk
Converting my 294 elan to a mikuni. Tried tons of research of installing a 34mm. Has been done from what i read just no luck finding a breakdown on what anybody has used for guts..... anyone have any input? If i cant find much info i will be doing a 30mm just have a 34mm on hand is all.
TIA...