Recent content by WhIpLaSh

apparently there closin down that whole area all thru summer. thats what E&S in ft sask. told me moments ago.

removed by user

Removed by user.

hi there, i have a set of 26" mudlites with sidewall damage. its about a 1 inch gash. its patched from the inside, holds air (apparently) should i run a tube inside and run an external patch as well??

it turned out to be that on off switch on the left hand grip, where the electric shift is. that buttin there is wore out or really finicky. it has a sweet spot. but thanks guys for the replies.

i have a 98 450 ES, had it stored at my buddys place. fired it up,no problems. loaded into back of my truck. brought it home, and now i cant get it too run....... any ideas?? i did for get to turn the gas off, was a 45 min ride. just happened. is it flooded?? too cold?? both?? shld i let it sit...

thank you very much snowhound63 it was that relay you said it was. saved me some money and some headache. thanks again:beer:

you will have to email me @ radw313@hotmail.com you cant receive emails thru snow and mud. says u have the email option blocked. my airbox should fit your ultra as well.

yup, i did,buy a Ski-doo. LOL , .......jk jk. do you mix your own gas?? is it oil injected??

in total, how much coolant have you used or gone thru, troubleshooting this issue??

did u recently change your fluid? or maybe lose alot of coolant than add some>? because, my xlt, when i changed the coolant in it, you have to elevate the front end of the machine so fluid flows to your heat exchangers, then you idle your machine and keep adding fluid til its fully topped up. if...

lol, well, i talked to the guy i bought it from, and he said it did it to him once b4 and he jus unplugged the main harness and replugged it in, and it worked. my machine is on my buddies acreage so i will try it again tonight.

hmmm. i hope thats all is wrong.ill try it tomorrow. anything else i should check?? whats worse case scenario ??

for sure, hope it works out for ya. good luck :beer:

i have a 03 summit 800 hymark. runs strong and great, starts 1st pull,goes beep beep when it fires up. BUT... my gauge lights and my headlights dont work. is there a secret button im not finding??? i just got the machine today, and just noticed no headlights or gauge lights. and yes i checked...