The problem turned out to be the center shaft on my primary expanded a few .001's. It must have heated up pretty good. Anyhow, the expanded shaft was not allowing the bearing to slid eup and down the shaft and engage teh clutch. Ended up replacing the clutch with a used one for $200. not too...
I have an 05 Fusion 900. I've heard that teh comp fusion motor mounts are a necessity. Can anyone tell me what these are and if they really are necessary? They are over $300. Does this really address teh vibration and consequently the problems that arise from it?
has anyone installed an electric start on the 900 Fusion? I picked one up for $150 so I thought it would be worthi tto throw it in there. Anyone have directions on how to do this or know where to find them?
I recently blew a belt and at the same tiem broke a spring in my clutch. After replacing both I have a problem with my reverse. I didn't notice this at first because after replacing the parts I had the sled up on a stand and tested the new belt and spring in both forward and reverse. Off the...
What adjustments ned to be made on an 08 Nytro RTX to help keep the skis on the ground. I'm new to the Nytro after riding Polaris and Cats for 10 years so I am not familiar with the whole suspensin set up on this sled. My issue is a do a lot of hard trail riding in tight areas and when I ch!t...
Ask the dealer where the 12V ignition wire is at. I use this on my Nytro for 12V to my GPS. I simply used a scotch block to tap into teh wire for the 12V source. Once teh scotch bloch is on the wire you can use teh other part of the scotch block to carry the 12V wherever you need it. The...