Recent content by Ruegsegger

Try going to a website with an OEM parts finder and look up the diagram to see if it shows you the location.

Awesome! Thanks for the heads up!

Hey guys, I've been looking at threads all over the net about this and from what I have read sleds up to 2009 have the stock output shaft machined for 5203 and also BDX brand gears are still machined for 5203 but apparently stock 2010/2011 CAT output gears have a slightly shorter surface for...

If I wasn't signed on to a contract for another 1.5 years I would have done it in a heartbeat! Wanna pay out my contract or wait 1.5 years? Lol

It's not too bad, you will need a tool to compress the clutch spring ( buy one or get a piece of threaded rod with nuts and washers on each end). Compress the spring a little and then remove your 6 torx screws that hold the helix on the sheave. Once you have the screws out you can now realease...

On a side note* Make sure that the circlips holding the wrist pin are not installed with the gaps straight to the side, I have seen circlips pop out when installed like this because of G-forces at high RPM's. Good luck.

I wish I had saw this post earlier! Is there any chance you guys will be doing another demo sometime this winter?

Just make sure you order a U.S. model because the Canadian version only comes with a 2 watt radio due to regulations.

Check your power valve cable length I can't remember what the measurement is but you have to be pretty close to make sure they open at the right time. Also check to make sure the powervalve servo motor is working it should turn on around 6500rpm. If you sled starts bogging around 6500rpm it more...

I have a bikeman kit that comes with torsional secondary conversion on my m7 153" and it works very well in deep powder but the primary spring is fairly stiff so the clutch engages really hard which is not the greatest on the trail. I have not tried any other set ups tho.

I was trying to be sarcastic, sorry if it came across the wrong way Al "Ley Cat".

Hahaha, Ya thats what I'm thinking its gonna be like. I might have to pack a few extra hand/toe warmers to make it through the night!

Well I just booked a room at the McBride Hotel for this weekend and was wondering how bad this place is? A double room costs $55 a night and she told me to pick up the keys in the bar downstairs lol, which leads me to believe this is an extremely classy spot! Just wondering what to expect. I...

Alright thanks for the tips!

Thanks for the reply. The rubber mount in the plate itself is fine its the hole in the bulkhead for the bolt that is chewed up (your 2nd pic). The bolt just spins in the hole since its been enlarged so I am going to take my throttle bodies out and try hold it with a pair of vice grips, then I'm...