Recent content by mrsummit700

Alright So i installed the can and it sounds pretty damn good Thanks for the input Old-Soul

I made the Diy flywheel puller using a 2x4 and 3 5" 5/16 all thread rod and can't seem to pop the flywheel (Yes I removed the nut) (Thread Closed)

Total Rec Toronto They seem to be pretty good or check out Redline Cycle & Auto Salvage - Motorcycle ATV Snowmobile Parts

The insert is hollow minus the thin covering at the end of it ... I've applied jb weld and a bolt...hopefully it works

My story starts off with a stator bolting coming loose and smacking around freely in the crankcase. (see picture posted) Then to add icing to the cake...Bad weather bring down a tree on top of my little work shop and takes out 1 spark plug and temp sensor (see picture posted) (Yes the engine...

Did you have a problem with their product or just don't like them ?

Id like to be able to do wheelies and ride in the mtns as well .. Are there pre drilled holes or do I just take a guess ? I was thinking of leaving at least a inch so that the shock is not fully out ..???

Limiter Strap To remove or not to remove That is the question .. Are there any benefits ??:beer:

Not sure about your sled but I left the sensor in the original airbox didnt cause any problems

Please Post New pics and related info Love the sled SiC

Ill give it a shot and report back Thanks for the input guys

I've heard this before when I first joined the site.. Is there a difference in back pressure ? and if so How much power does a person lose?

Looking for a aftermarket can for my 2000 summit 700 (mbrp preferred)

I eyeballed the alignment while the sled was up on the lift. Haven't blown a belt yet

So I don't have the oem removal tool.. There is another way of doing the removal ? Any help would be great 2000 Summit 700 High Mark