Recent content by Danstoys

Yep be going to dealer tomorrow and see if I can borrow one or buy one. No dealer in my town so was trying to save time thanks.

Thanks for the info

Yep going to try the water but need a bolt

Do anyone know what threads are in primary clutch they are different then the ones in crank. Thanks

Just marking piston tdc on one piston and the putting the other one a bottom and then making sure other piston still on tdc mark If crank went out mark will or should be off. Got head off looks like pto piston has wear on intake side I can see rings but not very much, I’m used to seeing holes in...

Measured crank one piston on bottom other at tdc seems good, did compression test pro side 70 mag side 120. So I will start there and pull head. Thanks.

Thanks for info I have sled back going to do more investigating tomorrow before I make any decisions. I will measure pistons to check crank.

Well brought sled to dealership because I figured it was electrical, turns out my crank is gone out. So I plan on pulling motor sending to iantommsi and getting a full rebuild, welded crank new bearings pistons head work and porting. Hopefully it will work good after that and be reliable. If...

Picked up a 2012 800 rmk pro. It seemed to work good at first but I noticed it wasn’t burning much injection oil. I did some research and seen you could turn up injection pump, I was going for a ride that day so I just put some oil in the tank. The next day I turned up oil pump drained gas put...

From NL Canada. Couple kids, Snow 2012 800 rmk & 1000 Yamaha venture. Mud rzr 4 900 and 250 sx Ktm.