Helping install a bmp durability top end kit in a 2013 pro rmk. Anyone have specs? Ring end gap, piston to cylinder clearance, cylinder torque, head torque, etc. Any help would be greatly appreciated! Tia!
Yes I know what you mean, don’t want too heavy of base weight up high, no room to adjust. However I think with 67g base weights I should be okay as I have 68g weights right now and was still pulling around 8300 rpm in the mountains last year. We very rarely ride above 8000 ft
I am putting the 21/49 gearing in my 2016 M8000 Ltd 3” 162”, and also want to put in the Dalton adjustable weights. What is everyone’s experience with them and what size of base weight do you normally run? Was looking at the QA2-67’s, or the QA2-70’s(adjustable from 67g to 74.4g on the 67’s or...
Anyone install the new style 2018 cat grips on a 2016 M? Not sure whether I need to change the grip heaters or if the new grips will just fit right on?
Good to know, always something no matter which way you go lol. D/r is the real fix, just not a cheap option. I was also going to swap out the stock 68g weights for 70g no matter which way I go as well. Very seldom I’m over 7000’, even where we ride in the mountains.
I’m also thinking about putting in 8t drivers with stock 19/50 gears without d/r. I’m told they are tight but they work and is a better way to go than 21/49 gears. Anyone have experience with this? And even if it does fit, does it cause any issues running that tight of tolerance?
Okay thanks for the info! So did cat change to an aluminum lower gear? I know on the 2013 I had, the lower gear seemed much heavier, this one damn near feels plastic lol. Also found on the 2016 I am changing my chaincase oil a lot more because the oil gets silvery way faster due to faster wear...
I have a 2016 M8000 Ltd 162 3” I bought last year. I rode it for the season but found it to be geared too low. I know d/r and 8 tooth drivers would be best but not interested in spending the cash. I have been looking at the bdx 21/49 set up. Just wondering if anyone has used this kit and if it...
Anyone ever run the skidoo xps oil in a 800 proclimb? I work at a dealership that stocks the doo oil so I get a deal on it. Was thinking of running it in my cat. Anyone ever do this? Any issues?
Have a 2013 can am renegade 800 that is leaking oil from the rear end. I replaced the input shaft seal on the rear diff thinking it was coming from there but it looks like it is leaking through the splines between the input shaft and the driveshaft. Is there anything supposed to seal that? Or...