Recent content by calgarysledguy

🍺

Mine has been great. I wheel it around all the way up. About 10 years old.Makes it easier to work on and move around the garage. Long crank handle but I just use a drill... I pre drilled a chunk of 2x4. Use a lag bolt through bottom hole. Then cut another block and screwed it to the other, so...

This thread is useless without pictures.

Tell Ken it's about time he got to test out those recalls! 😂😂😂 I believe I met you at the A&W September long weekend. I was out fishing with my dad.... Anyway looks like you had a great day. I only found 70cm where I was Saturday. Ken know where and it cost me a A arm 🙄

Maybe for the srx's lol

Took a drive to the staging areas today. Everyone start doing the snow dance. More is needed, I'm sure that is not a surprise to most. 4-5 inches tops in deepest spot.

It's open until April 30 👍 Probably is snow. But probably some dirt sections too.

And how did you make out? Updates are always great 🙂

Make sure you have insurance and registration on sleds if riding out there. They do check.... I'd say it's a pretty good hall to get to cabin on a kids snowmobile.20-25km pending on route taken. Judging by pdf map link. Not saying it's not possible. It is located on the farthest south/west side...

Too much whiskey before posting this one🤔🤔🤔 https://www.kijiji.ca/v-snowmobile/edmonton/2019-polaris-850-rmk-pro/1653369743

😆 I go to get away from the family. Lol All jokes aside, I do sled with the kid but forcing him to ride tick's me off. He's still ripping the 120, almost ready for cataract, if he ever asks to join me...

🤔🤔🤔🤔🤔🤔 https://www.kijiji.ca/v-snowmobile/edmonton/2014-polaris-pro-rmk/1647727044

Wow that's a busy day. Good old Fording sugar. Warmer weather and minimal New snow in the last month. It's crazy how far the coal dust will travel. Have seen the layers back there in snow pack from the dust. Even see it on the sled/floor of house after drying gear out.

No I don't work there. Just sharing.

I would just unplug the reverse button wires. It's a small connector under the hood. You have to unvelcro the wire/connector protection bag... Use a multimeter and check continuity while pushing and not pushing the button on the button side of the wires that will eliminate the switch being the...