2005 Brute Force 750 belt reset problems

98sumitt

Active member
Joined
Jan 1, 2009
Messages
43
Reaction score
0
Location
THREE HILLS
Hi guys,
Currently working on a 2005 BF 750 on which the belt light won't reset-- actually it will reset until I crank over engine to start, then belt light comes on again. Occasionally, it will stay off for 2-3 test starts then will come on again. Actuator switch is always still in the "on" position. The quad does not actually have the correct battery on it, which is only about 1/2 the CCA that the proper one has, but is brand new. Is it possible that a voltage draw when starting, trips the belt light?? After about 40 tries, I'm looking for advise. Am also willing to bypass the belt switch, but simply putting a jumper across the switch wires doesn't work, so is there another method? Thanks for any advice you can give.
 

kygreen

Member
Joined
Nov 16, 2012
Messages
9
Reaction score
2
Location
Timmins
Hey there,
i beleive the switch is suposed to be off. . I could be wrong, also check the connections and the belt really good , to make sure you reset the belt properly there is a couple good utube videos hth :)
 

kygreen

Member
Joined
Nov 16, 2012
Messages
9
Reaction score
2
Location
Timmins
Hey there,
i beleive the switch is suposed to be off. . I could be wrong, also check the connections and the belt really good , to make sure you reset the belt properly there is a couple good utube videos hth :)
you can tell the way it goes by the direction the belt turns, a peice of belt would flick it to tripped position
 

750 kawi

Member
Joined
Aug 14, 2009
Messages
22
Reaction score
4
Location
Millet Alberta
It has to be something other than the switch, cause i know you can jumper the switch. I did it on the trail on my bike, maybe a broken wire somewhere along the line?
 
Top Bottom