Replacing spark plug wires

gibsons

Active VIP Member
Joined
Nov 14, 2009
Messages
8,450
Reaction score
4,723
Location
Blackstrap Sask
Want to replace the spark plug wires, but cat says they're apoxied in. Anyone have luck replacing them? Rec supply sells a splicer for them, but I don't really want to go that route. The wires are worn from rubbing on each other, and one cap concerns me cause twice it has pulled off on me. tension seems tight on the spark plug wire, so I don't think I can get away with cutting 1/2 inch off the end unless I can maybe move the coil a bit.
 

kimrick

RIP Fellow Sledder
Joined
Nov 28, 2009
Messages
2,236
Reaction score
6,304
Location
In Heaven & Revelstoke
See what happens when you go over to the dark side.....LOL

Should have stayed with the doo's......

Been here basically all winter. When are coming out?
Shoot me a text and we can hook up for a ride.

Good luck with your lpug wire repair.
I am sure someone has done them on this site Trav.
 

gibsons

Active VIP Member
Joined
Nov 14, 2009
Messages
8,450
Reaction score
4,723
Location
Blackstrap Sask
Oh I'm still on Doo Richard, just working on buddies machine. Yeah I want to hook up with you, so I will shoot you a text when I figure a date to come out, but likely later Feb or into March.
 

readimedic

Active member
Joined
Nov 13, 2015
Messages
46
Reaction score
22
Location
saskatchewan
You can pull them out if you turn them. I put loom on my wires for that particular reason. No more problem.
 

gibsons

Active VIP Member
Joined
Nov 14, 2009
Messages
8,450
Reaction score
4,723
Location
Blackstrap Sask
Managed to fix the wires, but my problem still exist. At Full throttle, it would be like someone is burping the throttle, but this time the sled just died like it did last year on buddy. Now no spark. So far what I have found to fix were, two wires on one of the plugs for the ecu wore thru from rubbing on each other. The two wires going thru the brass fitting, into the fuel tank, had worn thru on the brass.
 
Top Bottom