Search results

Curious to hear what the face run out is when it's bolted on a motor and a dual indicator is put on it. Pull plugs and turn it over. Did you make a fixture to hold the taper? Riding old sleds

Shorts "good humans" and some brownies. Too bad they only sell it in and close to Michigan Riding old sleds

Kind of an off the wall question, do the lynx sleds come in a G4 type of platform. Those lynx were always overly built like tanks. Any idea if they have been having bulkhead issues if they are the same G4 type platform. I suck at searches like that, anybody got any info. Riding old sleds

I like the idea of turning the skis around on the tow sled. Riding old sleds

A good portion of the weight difference is the SHOT starting system (-20 lbs.) on the summits but not on free rides I believe. Riding old sleds

Additive to oil or gas, not a replacement for oil. Riding old sleds

Maybe there is a way that the pivot on the bottom of the bar post has somehow got to a point that the pivot point has flipped the rod to the wrong side. Shine a light down in the belly pan and look if something looks really out of place. Doubt it, but worth a look Making JIS screws into junk

Pipe plug taper puts more stress on it when tightened and could actually crack it easier. Just drill and JB welds it. Making JIS screws into junk

I bet that they put that on so they only have to change part of the cord to put another connector on to fit another countries power socket to it. Making JIS screws into junk

Strain gage based stress analysis. Anything from weighing an egg to a 250k load cells for NASA. A lot of automotive and agricultural parts for testing. Making JIS screws into junk

I had a similar set up on a little nisan pick up, but mine was the height of the wheel well tops. Made the approach angle to load a lot lower. Would your deck fit between the box sides? Making JIS screws into junk

Oh, no, not quite.... Just look up the condoms of old days. Not quite the same a today. Making JIS screws into junk

Any body pick up on that little line where negan says to the guy ready to kill Darrel. He stops him and then says something like wait til you "try it" . Sounds like Darrel is getting set up for a little forced back door action from those guys Making JIS screws into junk

There is a company out there that makes a wear rod with rectangular piece of carbide in it. As the rod wears around it you end up with a tall deep carbide chunk that is only about 1/8th" wide. Not razor sharp, but because it is such a slim profile it bites good. Maybe search self sharpening...

I know a lot of guys over on the honda twins motorcycle forum are using a john deere lawn tactor regulator/rectifier. I did the swap on a old motorcycle my wife has, seems to work fine. A search should come up with the swap and part number. Sent from my PC36100 using Tapatalk 2

Hokey pokey. You put your big one in, you pull your big one out, you put your big one in and twist it all about. Sent from my PC36100 using Tapatalk 2

Nice exhaust tip on that diesel!! I guess he had to advertise his big nuts on his receiver too. Idiot. Sent from my PC36100 using Tapatalk 2

Sirkdev, Yeah, can't wait to see these truck driving in the salt mist coming off the roads after they salt them during slushy/icy conditions. All of a sudden, the truck has become only a fair weather vehicle. Sent from my PC36100 using Tapatalk 2

I'm not 100% sure on the doo throttle block, but if you look at the throttle block you will see a very small plastic piece that the thumb lever touches. On my old polaris there is one on the front side of the thumb lever and one on the back. If the throttle lever doesn't move in the proper...

Throttle safety switch? Sent from my PC36100 using Tapatalk 2