Search results

Just about to order the p85 from fasttrax. I'm running a silver spring and 68g weights. Elevation is 2500-6200, riding is mountain/ boondocking. Any recommendations on what I should run on the p85 I have know idea where to start.

Just got my skid back in, can any one give me an idea of what to set the track tension at and where I should be checking it.

Check the buttons make sure they are still there.

Can anyone help me with resistor size when putting an led tail light on a 2006 m7. I'm not running any other electronics.

That's exactly what I want, gotta see if I can buy it on ebay or in Canada. Shipping through them is twice as much as the light.

Ya I seen those looking for something smaller I think.

Just put a van amburg 1/2 tunnel on my 06 m7. Need a new tail light. Does anyone have any suggestions.

I had to replace my primary this year and it was a nightmare. It started with a borrowed clutch puller and it was a good one not one of the cheap pos ones. Then I ran cold water on the crank and put a little oxy heat to the clutch. Started losing it at this point. Eventually had to resort to die...

Just did mine today, super easy. Wish I would have replaced the helix bolts now. I didn't have to use heat on mine. I also installed the updated rollers. The pars guy at arctic cat told me the new rollers that are made of some kind of composit can crack or shatter on the sleds with reverse.

Rear of my tunnel is starting to buckle. I was looking at the VA bumper but managed to convinse the misses that the 1/2 tunnel was what I needed. I've seen some bad reviews on the boondocker tunnels and coolers i.e. bad fit, poor quality. Does anyone else have the half tunnel installed and...

Thanks a lot. Got it all apart no problems with the screws.

Time to replace the rollers on my 2006 m7 driven clutch. Does anyone have a link for disassembly instructions?