Recent content by Woodsie1984

The old hammerhead 19’ v8 does pretty good in the shallows

Ya I Havnt been on the Murray when it was that low….definitely makes it challenging

Ended up just taking a chance and went. Water level is definitely low! But so much fun to run! Boat launch was not great as your trailer just falls off the ramp and gravel bar is right there. But was a beauty day and no stucks. Sent from my iPhone using Tapatalk

Anyone know if the Murray river is open up to the falls yet ?

Haha..ya I was not happy…I tried just hot water first but nothing so I added shots of air and boom out it came Sent from my iPhone using Tapatalk

I’m actually doing my dad’s 2020 high country next week cause his is the same issue heat only on passenger side. Sent from my iPhone using Tapatalk

I have a 2020 3500 gmc had same thing happen…was over on gm warranty have extended warranty but they wouldn’t warranty it cause it was “plugged” not man defect…I was pissed…they wanted 2500$ to replace it , told them to Pound sand..made my own device to unplug the core myself. Flushed back and...

Yes I have both round tube and pipe dies

That looks good! It’s Deff the right size die. I’ve tried dish soap and a ton of it where it’s dripping off the aluminum and still no luck…helped a little bit but still gouged it. I went to 6063 pipe cause it bends with out cracking and don’t have to anneal every bend. I tried a piece of 1 1/4”...

Ya I’ve used the acetalyn soot trick to anneal aluminum round tube as that’s all I could get it in is T6. But now I’ve got pipe dies cause I can get less temper in aluminum pipe. So I don’t need to anneal it anymore as it’s not cracking. But for some reason it’s grabbing super hard and gouging...

It’s a brand new die, tried bugging it little bit just make sure no sharp edges. Could try grease I guess..just hard to get off and need to weld on it too. Maybe I’ll try the pre heat Thanks

Sent from my iPhone using Tapatalk

Anybody here use a baileigh pipe bender on aluminum ? I my currently having issues trying to bend aluminum pipe with mine. Using 6063 1 1/4 aluminum pipe trying to build a wake tower for a guy. It keeps gouging the aluminum when I try to bend it. I’ve tried soap soapy water, wd-40, pipe...

Just finished this dinning table for our new home. Once again I used only zip cuts to cut all the metal. I have over 100 hours into this table but I’m happy with the way it turned out. Used 2” solid black walnut with a natural finish.