Recent content by redneckoutty

I blew up my rear diff on my 2011 outlander. I found a used diff from a renegade. Does anyone know if the Diffs from a renegade have the same gear ratio as the outlander? And will it bolt up? Thanks.

Thanks Dave

I bought a stm secondary for my 2011 outty 800 and I'm gonna upgrade to a new 1000 does anyone know if the STM off my 2011 will fit a new 1000 outlander?

Hey guys lookin for some advice. I'm running a 11 outlander 800 with 28" silverbacks. I took it out last weekend and roasted my belt in a hole. I'm not sure if I should put a clutch kit in it or go with a aftermarket primary or secondary clutch. Is anyone running different clutches and how do...

My buddy is runnin 28 inch silverbacks on his outty 1000. Works good. Don't need a lift to clear them and he is running stock clutching. But it is hard on axles and tie rods.

anyone got any pic of their outlander or renegade with 28 inch backs?

im looking at buyin a set of 28'' silverbacks for my outlander 800. Will they fit without a lift? im planning on getting a clutch kit too suggestions? Also how will stock axles hold up? thanks

But will it do any harm to the engine? Shouldn't the efi adjust enough to run a slip on?

I have a 2011 outlander 800 can I run a slip on exhaust without an optimizer? Is it safe to run it without one? I've heard it will cause it to run lean and cause catastrophic engine failure. Thanks.

hi im new to the fourms and i just bought a 2011 outlander 800 and i dont know wat tires to put on it. I would like a large lug agressive tread but also something you can ride on trails. also im undecided on tire size. if i should go bigger then 27s. any advice is appreciated.