Recent content by gigger

Ok, I'll give that a try, I did pop out the center area, but I was only pushing on the pin with a small screwdriver and never tried a paperclip. Thanks, ya they should have made it so you just plugged it into a harness, moving wires like this is crazy.

Have you tried both high and low? I would assume only the high is burnt out which means you need a new element and they are east to change I just did the same one on my 13. If neither work then I would take the throttle assembly apart and check for power there on both high and low side. If no...

Hi, I tried installing the factory kit and I found the right wires, but I could not get the wires out of the harness! Any tips or tricks I hate to rip it all apart again to not get the wires installed.