Yes there is a flange up near where it attaches to the throttle bodies, on the clutch side of the intercooler. I don't have time right now for a pic but i will post one soon.
Did you get the tube welded on in that spot?? My intercooler has a spot on it for a BOV. Does it matter where I install it? I am installing a BOV also.
Sounds like you got it running good. Just a question, is there any place to go for a late ride, would be nice to get one more ride before I put it away? Thanks
Sounds like you're heading in the right direction. A little gasket sealer won't hurt, but be careful not to let any get in the tank. Just a little noe also, sometimes these copper gaskets can be over tightened and they havew a tendancy to crack and then you got a leak. Check to make sure the...
Hey Shawn, I was disappointed with it my first ride, didn;t have the power and just around 5 psi of boost. It wasn't what I expected. It took some time to figure it out, but after I called MPI and they told me what to do, it was instant fun. My pulleys came with the wrong setup. The bushings for...
Hi. I did a lot of tinkering with the weights and secondary. The best setup that seems to be working for me right now, I bought some Dalton Pro adjustable weights for the clutch and a shockwave for my secondary. Can't remember the weights I used, but i know that I am using heavier than stock. My...
Hi There. I bought an MPI super charger this past winter. I called MPI and asked them what could be run in this set up. I bought a Stage one kit and it is supposed to put out between 10 and 12 PSI of boost. They told me to run a 50/50 mix with this set up. I asked them what pulley combination I...