LoginRegister
SnowandMud.com - Powered by vBulletin

Today's Posts
Page 1 of 3 123 LastLast
Results 1 to 10 of 29

yamaha codes

Discuss yamaha codes in the YAMAHA CHAT forums; -------------------------------------------------------------------------------- Here is a list of trouble codes for Yammis (Genesis 120 engine): 15 - Throttle Position Sensor and Circuit ...


  1. #1
    jbb
    jbb is offline
    Senior Member
    jbb's Avatar
    Join Date
    Aug 2008
    Location
    k town
    Posts
    20,283
    Post Thanks / Like

    yamaha codes

    --------------------------------------------------------------------------------

    Here is a list of trouble codes for Yammis (Genesis 120 engine):

    15 - Throttle Position Sensor and Circuit problem
    16 - Throttle Position Sensor stuck
    21 - Coolant Temperature Sensor and Circuit
    42 - Speed Sensor
    46 - Power Source Voltage
    80 - Grip Warmer Switch and Circuit
    81 - Grip Warmer and Circuit
    82 - Thumb Warmer Switch and Circuit
    83 - Thumb Warmer and Circuit
    84 - TORS System Activated(throttle override)
    86 - Cold Engine Protection Activated


    hope this helps some of you!
    I WOULD'NT HAVE TO LEARN TO MANAGE MY ANGER, IF IDIOTS LEARN TO MANAGE THERE STUPIDITY .......



  2. #2
    Member RaspberryNytro's Avatar
    Join Date
    Jan 2008
    Location
    Airdrie & Oman, in Middle East
    Posts
    576
    Post Thanks / Like

    Re: yamaha codes

    Thx jbb............. that'll come in handy someday!!!

    RN
    Never test the depth of the water with both feet!!!
    14' DOO XM sp 163 With a few goodies from Racer's Edge...
    15' XM X T3 174 on order ... Goodies will come later !!!
    08 Lifted Dodge Ram with 35" tires... Check

  3. #3
    jbb
    jbb is offline
    Senior Member
    jbb's Avatar
    Join Date
    Aug 2008
    Location
    k town
    Posts
    20,283
    Post Thanks / Like

    Re: yamaha codes

    Yamaha Error Codes for Apex, Attak, and Apex Mountain models


    Code #
    Item
    Symptom
    Fail-Safe Action Starting Capability Running Capability
    11 Cylinder identification sensor No normal signals are received from the cylinder identification sensor Continues to operate the engine based on the results of the cylinder identification that existed up to that point Unable Able
    12 Crankshaft position sensor No normal signals are received from the crankshaft position sensor Stops the engine (by stopping the injection and ignition) Unable Unable
    13
    14 Intake air pressure sensor (open or short circuit) (pipe system) Intake air pressure sensor-open or short circuit detected.
    Faulty intake air pressure sensor system Fixes the intake air pressure to 85.0 kPa. Able Able
    15
    16 Throttle position sensor (open or short circuit) (stuck) Throttle position sensor-open or short circuit detected Fixes the throttle position sensor to fully open Able Able
    20 Intake air pressure
    Atmospheric pressure Defective values are detected due to the internal malfunction Fixes the intake air pressure and atmospheric pressure to 85.0 kPa. Able Able
    21 Coolant temperature sensor Coolant temperature sensor-open or short circuit detected Fixes the coolant temperature to 600 C. After the engine starts, the radiator fan relay will be turned on. Able Able
    22 Intake temperature sensor Intake temperature sensor-open or short circuit detected Fixes the intake temperature to 00 C. Able Able
    23 Atmospheric pressure sensor (open or short circuit) Atmospheric pressure sensor-open or short circuit detected Fixes the atmospheric pressure to 85.0 kPa. Able Able
    30 Oil pressure dropped Engine stops when the oil pressure drop is detected Fuel pump and fuel injection are stopped (main relay is off) Unable Unable
    33
    34
    35
    36 Faulty ignition Open circuit detected in the primary lead of the ignition coil Cut the injection of cylinder in the same group with the cylinder that the error is detected. Example, when the #1 cylinder is defective, cut the injection of #1 and #4 cylinders. Turn on the power to the air induction solenoid to always cut-off the aire Able (depending on the number of faulty cylinders) Able (depending on the number of faulty cylinders)
    42 Speed sensor No normal signals are received from the speed sensor Assumes highest ratio Able Able
    43 Fuel system voltage (monitor voltage) The ECU is unable to monitor the battery voltage (an open circuit in the line to the ECU) Fixes the battery voltage to 12 V Able Able
    44 Error in writing the amount of CO adjustment on the EEPROM An error is detected while reading or writing on the EEPROM (CO adjustment value) n/a Able Able
    46 Vehicle system power supply (monitor voltage) Power supply to the FI system is not normal Grip warmer output is off Able Able
    50 ECU internal malfunction (memory check error) Faulty ECU memory. When this malfunction is detected, the code number might not appear on the meter n/a Unable Unable
    80 Grip warmer switch Grip warmer switch-short circuit detected n/a Able Able
    81 Grip warmer Grip warmer-open or short circuit detected n/a Able Able
    82 Thumb warmer switch Thumb warmer switch-short circuit detected n/a Able Able
    83 Thumb warmer Thumb warmer-short circuit detected n/a Able Able
    84 T.O.R.S. Detecting conditions for T.O.R.S. are satisfied n/a Able Unable
    85 Oil pressure switch Oil pressure switch-open circuit detected n/a Able Able
    - Start unable warning Relay is not turned ON even if the crank signal is input while the start switch is turned ON. When the start switch is turned ON while an error is detected with the fault code of number 11, 12, 30, or 50. Engine trouble warning light flashes when the start switch is turned on Unable Unable
    I WOULD'NT HAVE TO LEARN TO MANAGE MY ANGER, IF IDIOTS LEARN TO MANAGE THERE STUPIDITY .......

  4. #4
    Member shiznitt100's Avatar
    Join Date
    Dec 2007
    Location
    The Gar
    Posts
    343
    Post Thanks / Like

    Re: yamaha codes

    trying to post a service manual for 2006-2009 apex the file is 16mb and having a hard time posting it, i will try to split it up to 2 downloads. has all codes, all mechanical, ect. it is a complete yamaha not the crap haynes

  5. #5
    Senior Member
    Rob1334's Avatar
    Join Date
    Sep 2008
    Location
    Bismarck, ND
    Posts
    11,292
    Post Thanks / Like

    Re: yamaha codes

    Look how helpful this banned man is!!!!
    _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

    I got nothing.

  6. #6
    Member shiznitt100's Avatar
    Join Date
    Dec 2007
    Location
    The Gar
    Posts
    343
    Post Thanks / Like

    Re: yamaha codes

    i guess i have been away too long i missed the banning lol sorry to hear jbb thanks for the codes

  7. #7
    Member RWoods's Avatar
    Join Date
    Oct 2009
    Location
    Alberta
    Posts
    8
    Post Thanks / Like

    Re: yamaha codes

    This may be a silly question but do these codes apply to the Venture sleds as well. Father in laws sled is coming up with a 00021 Oil flashing in the display.

    Any help would be great.

  8. #8
    Member shiznitt100's Avatar
    Join Date
    Dec 2007
    Location
    The Gar
    Posts
    343
    Post Thanks / Like

    Re: yamaha codes

    does the oil light go out or does it stay on?, if you roll a yamaha the light will stay on for a few mins then should go out. check your oil level and sender. make sure it has good contact, also check connector at comp at front of sled, make sure there is no water in the connector



  9. #9
    Member crosroads's Avatar
    Join Date
    Oct 2009
    Location
    St. Michael
    Posts
    64
    Post Thanks / Like

    Re: yamaha codes

    Thanks for the info, should come in handy someday.... wonderin if they apply to the phazer too?

  10. #10
    Member RWoods's Avatar
    Join Date
    Oct 2009
    Location
    Alberta
    Posts
    8
    Post Thanks / Like

    Re: yamaha codes

    Oil light does not come on at all. Oil 00021 just flashes on the display screen. Have checked all levels and all connections but still no changes. Has been in the garage so water wont be an issue. Got any ideas??

LinkBacks (?)

  1. February 17th, 2014, 08:29 PM
  2. February 27th, 2013, 07:56 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


Search Engine Friendly URLs by vBSEO