rhino clutch info

rotormech · Jan 10, 2011

i have 05 660,question,should the belt on the primary be sitting right on the bottom of the shieves,mine is sitting about 1/4 of the way up the shieves,mabey a shimm problem?it seems like the belt is to long,but it isnt,got a new one anyway.

AreWeThereYet · Jan 10, 2011

It should be sitting up from the primary shaft or it would just spin because there wouldn't be any pressure on it. It should not be touching the primary shaft and it should be sitting about even with the secondary sheave with a new belt IIRC.

You can also measure the belt to the new one.

northern bear · Jan 10, 2011

The belt should be tight on the sheaves at all times, as the primary doesn't do the actual engagement. There's a centrifugal wet clutch in behind the primary that does that.

rotormech · Jan 10, 2011

thanks guys,i was just going by sled experiance,that makes sense..

rhino clutch info

rotormech

Active VIP Member

AreWeThereYet

Active VIP Member

northern bear

RIP May 30,2022

rotormech

Active VIP Member

Similar threads