xmr wont idle after winch replacement.

[skor]

Hey guys, I replaced my winch over the weekend and after installing the new winch (block and other modules) had to give it gas to get it to run. While holding the throttle the xmr will run no problem, but as soon as I let it go the quad just stalls.

The new winch works fine (even the wireless module) everything electrical works fine too (lights, heated grips, etc). Checked the fuses under the rad and all look ok.

Any ideas?

 

[floogan]

Could be the throttle freeplay should 2-3 mm
maybe ziptied wires to throttle cable
Connected 12v keyed on power source to wrong spot

 

[skor]

Could be the throttle freeplay should 2-3 mm
maybe ziptied wires to throttle cable
Connected 12v keyed on power source to wrong spot

Thanks! ... what a coincidence but the throttle cable housing must of have been broken, the zip ties were holding it in place when I cut the zip ties it loosen the cable. Once I found the issue used a temp zip tie and everything is working fine ;-)

Thanks

 

[sumx54]

Nice work floogan!