Slight problem / oversight :(

[Kenny_h2o]

So I did a track change and running board swap on my proclimb and on the chain case side, even when covered. I seem to have got some small metal shavings in there a bit and by the bearings... Right now I'm using rags to try and wipe it out ... I was wondering if anyone had any suggestions as to an easier or more efficient way of doing this? I'd like it to be fully clean...

 

[cokecrazed007]

Spray with wd40

Sent from my SGH-I717D using Tapatalk 2

 

[Kenny_h2o]

Thanks so much!!! And omg I'm going insane trying to get these damn snap rings on with no eyes in them.... Dang it!

 

[Riverjet]

..................

 

[Kyle91rs]

Thanks so much!!! And omg I'm going insane trying to get these snap rings on with no eyes in them.... Gosh darnit!!!!

YOUNG EARS!!!!!! HaBaha

i had the same problem tonight just getting em off. Stupid things.

 

[Kenny_h2o]

I tried to buy some that matched the size but I couldn't find any last minute.

I found that cutting the nipples off my 45 degree snap ring pliers worked best. Use the flat part and grab it from the top vertically. Takes some body English and have to like stand backwards and bend over to get at it right lol

I got the first one on with the nipples on but if you use the flat part it provides more of an opening force.


Sorry ill modify the post didn't realize!