What did you do for your ATV today?
- Thread starter zeebs
- Start date
- Moderator
- #4,122
I just use fingers for stopper
Frosty19
Active VIP Member
Previous quad didnt have one and.the winch thimble got stuck in the roller and I had a bit of a walk to get back and hitch a ride back for a pull from a mud hole.
Back on topic, went for a ride and tested the snorkels. Lots of water this spring, racks were underwater
Now.considering sending.my ECU to the states for a reflash to get some.more out of the 1000
- Moderator
- #4,125
papajake
Active VIP Member
have to wash sxs after rocky and get ready for iron horse trail ride
- Admin
- #4,127
I thought the washing was "ChubbyBunny" responsibility?
papajake
Active VIP Member
I will leave her in her kitchen to cook that is what she likes to do and it makes me happy and fat don’t poke the chubby bunny that feeds you or there be any chubby bunny if you know what i mean
- Moderator
- #4,129
- Moderator
- #4,131
rightsideup
Active VIP Member
i cut out a trail so the sportsman could roam
Beer Slayer
Active VIP Member
Help brother with his knock down trailer frame and temp. trailer hitch
Removed plastic...for now. Bolted and welded a piece of angle to frame/ATV.
Tube runs from front to rear.
Knock down temp. single axle frame [pins, bolts and ratchet straps]
...oops, drink holder and grips for his ol' lady...project from last year.
tongue weight and handling test drive around house to pads.
We are moving two twenty foot sea cans around back to be converted into a wood shop.
They will be bolted together side by side with most of the center walls removed.
Will be sixteen by twenty.
I believe cans get dropped off next week....
Removed plastic...for now. Bolted and welded a piece of angle to frame/ATV.
Tube runs from front to rear.
Knock down temp. single axle frame [pins, bolts and ratchet straps]
...oops, drink holder and grips for his ol' lady...project from last year.
tongue weight and handling test drive around house to pads.
We are moving two twenty foot sea cans around back to be converted into a wood shop.
They will be bolted together side by side with most of the center walls removed.
Will be sixteen by twenty.
I believe cans get dropped off next week....
papajake
Active VIP Member
Removed seized starter from the razor not an easy job put it back together this week after I pick up a new one last ride was seat high mud and water must have done it
- Moderator
- #4,136
Frosty19
Active VIP Member
Was checking over buddy's rzr for a cylinder misfire code that popped up, opened the clutch and saw the primary looking like this. 160km on the machine, warranty should also include a new belt I would think. First time I've seen something like that
doorfx
Active VIP Member
Took it for a ride to Mt. Baldy.
papajake
Active VIP Member
does anyone know where a guy can buy those bearing greasers in Alberta the ones that you can do with the spindle in
neilsleder
Active VIP Member
Amazon had them cheap
Similar threads
