Snorkel your atv warrior risers

• Mar 8, 2019

• #1

f7sp

Active VIP Member

Joined

Dec 4, 2007

Messages

223

Reaction score

51

Location

edmonton, alberta

For those who installed this snorkel kit, did you install the plastic caps and frogskin on the end of the risers or just leave them off? It looks like they will get restricted with dust and mud if they were put on, more worried about the intake than exhaust. It’s on an 07 grizzly 700.

 

• Mar 8, 2019

• #2

drford

Active VIP Member

Joined

Feb 16, 2009

Messages

435

Reaction score

86

Location

Grande prairie

I put on no problems yet exhaust is all that doesn’t have one

 

• Mar 18, 2019

• Thread starter
• #3

f7sp

Active VIP Member

Joined

Dec 4, 2007

Messages

223

Reaction score

51

Location

edmonton, alberta

It says the only place to not put the filter material is on the cvt outlet snorkel. I thought it would be the intake snorkels you’d have to worry about more.

 

• Mar 18, 2019

• #4

D.C

Active member

Joined

May 4, 2015

Messages

76

Reaction score

100

Location

Prince George

Biggest problem I noticed with mine was in the cold, frost would build up on them and my bike would run like sh*t. Dust stays off for a while after you clean them but the frost piles back on after a few minutes

 

• Mar 18, 2019

• #5

drew562

Active VIP Member

Joined

Mar 13, 2008

Messages

4,836

Reaction score

18,691

Location

edmonton

I have a set of 3-3” risers for sale If anyone’s looking

 

• Mar 21, 2019

• Thread starter
• #6

f7sp

Active VIP Member

Joined

Dec 4, 2007

Messages

223

Reaction score

51

Location

edmonton, alberta

I have 4 warrior riser tips with pre filter material for each tip for sale if anyone’s looking. They are for the 2”
riser.