Hey all.
I would post this in the cat section but I figured other sleds/sledders may have come across this issue.
Got a done up 2009 m1000(pipe,manifold,can and cold air intake) so I need a fuel manager.
Trying to run a power commander v but here is my issue, with the sled hooked up stock wiring to stock ecu all is good.
When I connect the power commander in between, the sled starts fine every time but leans out and dies within 20sec even at idle.
Tried the pc on my wife's m8 and it works perfectly.
I have no codes and my sled runs great without the pc, but is lean up top as expected.
I have swapped the pipe sensor and the ecu from the m8 with the same results so I know they are ok.
Have tested my main chassis ground and injector wires with an ohm meter and they are all 0.01 ohm which is good.
Pc has a good ground.
Have run the sled with my laptop attached and it is seeing rpm and tps percentage so they should be ok.
Really don't know where to go from here.
Sent a message to tech support and as expected never got a response.
Any help would be appreciated, thanks.
I would post this in the cat section but I figured other sleds/sledders may have come across this issue.
Got a done up 2009 m1000(pipe,manifold,can and cold air intake) so I need a fuel manager.
Trying to run a power commander v but here is my issue, with the sled hooked up stock wiring to stock ecu all is good.
When I connect the power commander in between, the sled starts fine every time but leans out and dies within 20sec even at idle.
Tried the pc on my wife's m8 and it works perfectly.
I have no codes and my sled runs great without the pc, but is lean up top as expected.
I have swapped the pipe sensor and the ecu from the m8 with the same results so I know they are ok.
Have tested my main chassis ground and injector wires with an ohm meter and they are all 0.01 ohm which is good.
Pc has a good ground.
Have run the sled with my laptop attached and it is seeing rpm and tps percentage so they should be ok.
Really don't know where to go from here.
Sent a message to tech support and as expected never got a response.
Any help would be appreciated, thanks.
