bikeman pipe on a etec

po-dunk

New member
Joined
Oct 22, 2017
Messages
1
Reaction score
0
Location
bc
I have the chance to buy a bikeman pipe for my 2011 e tec 800 for a really good deal. just wonder who has ran the bikeman y pipe and single pipe? did it make much difference? if so where did you notice t mot low?mid?top?
 

NoBrakes!

Active VIP Member
Joined
Nov 13, 2011
Messages
6,002
Reaction score
11,802
Location
Edmonton
I had a ceramic BMP y pipe and pipe with a specialty can on a 2014. Quality was good but light and thin. They say to run lower rpm, 7800 i think to take advantage. Didn't really notice a power gain but ran clean. Stock got bent, replaced with aftermarket.
 

slededjr

Active VIP Member
Joined
Nov 25, 2011
Messages
1,577
Reaction score
1,972
Location
sherwood park
Stock system gives the best performance throughout the entire power band. Some will increase bottom and mid but decrease top end, some increase mid and top but decrease bottom end. Ran the stock system on my ported engine ad stock engine and it worked the best IMO. Stock made best HP#’s on dyno for the ported engine but that will also very with porting.
 
Top Bottom